The appliance must be connected to an effective earthing installation, in compliance with the regulations in force.Mains cable replacement is only to be carried out by After-Sales Service.Do not operate the washing machine if it has been damaged during transport.Access to the mains plug or to disconnection from the mains supply via a double-pole switch must be ensured at all times following the installation.Before any maintenance on the washing machine disconnect it from the mains supply.Do not use extension leads or multi sockets.The manufacturer declines all liability for damage to persons or property deriving directly or indirectly from failure to observe the directions. The appliance must be connected exclusively by means of a socket with an earth connection in accordance with current regulations.The technical data (voltage, power and fuses) are given on the rating plate on the rear of the appliance.Electrical connections must be carried out by a qualified technician in compliance with the manufacturer’s instructions and the current standard safety regulations.If the washing machine is connected to a builtin drainage system, ensure the latter is equipped with a vent to avoid simultaneous loading and draining of water (siphoning effect).Connect the drain hose to the siphon or hook it over the edge of a sink with the “U” bend (see “Installation/Connect the water drain hose”).The warm water inlet temperature must not exceed 60° C.” Connect the water supply inlet hose in accordance with the regulations of your local water company (see “Installation/Connect the water inlet hose”).Adjust the feet to ensure that the machine is stable and level (see “Installation/Adjust the feet”).Place the appliance on a flat and stable floor surface.Before using the washing machine you must remove the transport bracket (see “Installation/Remove the transport bracket”).ĭo not forget to screw back 4 screws to the rear panel by which was fixed the transport bracket - to avoid noisy and vibration of the machine. The appliance is fitted with transport screws and a transport bracket to prevent damage during transport.Remove the bottom protection by tilting and turning the appliance on one rear bottom corner. Remove the top protection and the protective corners.Ĭ.

Awt 2284 user manual